Defining the 0.2 kW SIMOTICS servomotor
The 1FL2103-2AG01-0HC0 is a SIMOTICS S-1FL2 low-inertia synchronous servomotor from the Siemens 1FL2 family, sized for pairing with the SINAMICS S200 drive on 200 V three-phase supplies. Continuous rated output is 0.2 kW at a nominal speed of 3000 rpm, with both the standstill torque M0 and the rated torque Mn at 0.64 Nm — meaning the motor is dimensioned for cyclic point-to-point motion rather than constant high-torque operation, and the drive sizing follows the short overload profile of the S200 rather than the heavier S210/S220 frames. The shaft height is 30 mm with a plain shaft (tolerance N), no holding brake, and IP65 protection with oil seal — an oil-seal-equipped shaft end keeps light oil mist out of the bearing cavity and is the right choice on machine tools and packaging lines where gearbox leakage or airborne lubricant reaches the motor face. The feedback is a 17-bit single-turn absolute encoder (AS17 hybrid connector), matched to the SINAMICS S200 — a hybrid connector carries power and signal in one plug, and the AS17 protocol pairs only with the S200 control electronics, so cross-stocking onto an older SINAMICS V90 system is not plug-compatible.
Production status and BOM-fit
Lifecycle is recorded as active and current, and the part is produced to order under product class C — items are built per configuration and are not returnable for credit, so the BOM position must be firm before release rather than treated as shelf stock. Quantity unit is one piece with a packaging quantity of one and outer-pack dimensions of 315.00 x 182.00 x 172.00 mm — single-unit packaging means panel builders can order per station without breaking a multi-pack, but each carton still ships as its own logistics unit.
Compliance evidence on file
Export control is AL:N / ECCN:N, so the part is not license-controlled for standard commercial export shipments — paperwork stops at the standard commercial invoice, with no ECCN filing required for most destinations.
Group code and product group on the line card
Group code R220 and product group X0DJ position the motor on Siemens' ordering line card for the 1FL2 low-inertia family — useful when reconciling an inbound carton or a vendor-managed-inventory pull against the SAP material master, because a typo in those codes usually flags a wrong-revision motor long before the encoder cable is plugged in.