Active production, made-to-order line item
Siemens lists 1FL2103-2AG10-1SC0 as an active 1FL2 servomotor for the SINAMICS S200 drive platform. Lifecycle status is current on the manufacturer's record, so a build slot is open in the factory schedule — the binding procurement caveat is the product class: it is manufactured to order, non-returnable, and not eligible for credit on return. For a sourcing manager that means a cancelled BOM line cannot be refunded as stock; specify quantities to the actual build plan and treat any over-buy as surplus to be absorbed elsewhere in the line. Export-control screening is clean on both axes: AL: N and ECCN: N, so the motor ships without an export licence gate in the standard jurisdictions. Each unit ships as a single piece in a 315 × 182 × 172 mm carton.
Electrical and mechanical envelope
The SIMOTICS S-1FL2 frame is sized for 200 V 3AC supply with a rated power of 0.2 kW and a rated speed of 3000 rpm. Both standstill torque M0 and rated torque Mn are 0.64 Nm — the equality of M0 and Mn signals a low-inertia design intended to deliver rated torque across the working speed band without torque-derating dereservation at low speed, which suits indexing and pick-and-place axes where constant pull-out torque is the sizing limit. Shaft height 30 mm places it in the compact end of the 1FL2 line. Feedback is the 21-bit hybrid encoder carried over the AS21 hybrid connector — a single cable carries power and the absolute position feedback, which simplifies cabinet routing on a SINAMICS S200 axis. The shaft is supplied with a key and N tolerance, and a holding brake is included for vertical-axis or gravity-loaded applications where the drive must hold position with the bus de-energised. Protection class is IP54 without an oil seal — the motor tolerates light dust and water splash but is not sealed for coolant or washdown duty; that envelope is appropriate for indoor panel-side mounting away from direct coolant spray or food-grade wash zones. The matching drive is the SINAMICS S200, so the controller firmware auto-configures the 1FL2 parameters on first connect.
Compliance paperwork carried with the part
REACH Article 33 disclosure obligations are flagged via the official Reach Information link in the manufacturer record — a buyer specifying this motor into a CE-marked machine should pull the current candidate-list statement before shipping the assembled equipment, because Article 33 triggers whenever a substance of very high concern exceeds the 0.1 % w/w threshold in an article.