Match the S-1FL2 line to the S200 drive slot
The 1FL2103-2AG11-0MC0 is a SIMOTICS S-1FL2 low-inertia servo from the family sized for SINAMICS S200, with a 200 V 3 AC supply, a rated output of 0.2 kW, and a rated speed of 3000 rpm — both standstill torque and rated torque sitting at 0.64 Nm — which lines the motor up to the smallest frame in the S200 axis-count budget where a holding brake and IP64/IP65 sealing are called for. Shaft height 30 mm with a plain shaft (tolerance N) and an AM21 hybrid connector, paired with an integrated holding brake and an oil seal, tells the panel builder this motor drops into a compact axis — the kind of feeder, indexing table, or small-format conveyor position where the brake must hold a vertical or inclined load at standstill without an external clamp.
What IP65 with oil seal buys on a washdown-adjacent line
Protection class IP65 with oil seal at the shaft exit, combined with the AM21 connector interface, lets the motor sit on the wet side of a food, beverage, or cosmetics line as long as the cable gland on the mating connector is the sealing point — the housing itself is rated for jet wash but the connector interface is only as good as the cordset selected against it. Because the motor ships in a 315.00 x 182.00 x 172.00 mm pack and is sold by the piece, the integrator is buying a single-axis kit per drive rather than a multi-pack — drop-in spares need to be planned at the axis-count level, not as a bulk stock item.
Lifecycle, codes, and the compliance pack a broker shipment must carry
The motor carries Group Code R220 and Product Group X0DJ, and falls under Product class C — a build-to-order item that is not returnable for credit and cannot be re-used or re-utilised once delivered, which matters when a procurement clerk tries to cancel a slipped order.