30 mm-frame servo, 0.4 kW on 200 V 3AC
The Siemens 1FL2103-4AG00-0HC0 is a SIMOTICS S-1FL2 low-inertia servomotor in the 30 mm shaft-height frame, sized for 200 V 3AC supply at 0.4 kW rated power with a nominal speed of 3000 rpm and a continuous stall and rated torque of 1.27 Nm. Its 1FL2 family positioning ties it directly to the SINAMICS S200 drive line, which is the matching converter listed on the order code — pairing outside that drive requires re-validating the encoder and power stage mapping. Packaging dimensions for a single unit are 315.00 x 182.00 x 172.00 mm, which sets the cabinet cutout and cable-bend envelope behind the motor before the hybrid AS17 connector is dressed.
Mechanical build and electrical interface
Shaft configuration is plain (no keyway) with tolerance N and no holding brake — a brake-equipped variant is a different order-code suffix in the same frame, so confirm the BOM line before quoting. The feedback side carries an AS17 hybrid connector with a 17-bit encoder resolution, and the housing is IP54 without an oil seal — adequate for cabinet-internal mounting rather than direct washdown or coolant exposure. Quantity unit is 1 piece with a packaging quantity of 1, and the product class is C: made-to-order, non-returnable — order quantities match the BOM build, not a stocked shelf pull.
Lifecycle, compliance, and sourcing posture
Lifecycle stage is recorded as current with an active product status, so the part is in serial production on the manufacturer's books and not on a last-time-buy window. RoHS substance-restriction compliance has been declared since 01-01-18, and REACH Art. 33 disclosure information is supplied through the manufacturer — the relevant compliance pack ships with the order when requested. Export control is AL:N / ECCN:N, so no special license routing is triggered for standard cross-border shipments; independent distribution quoted against the BOM is the normal supply path.
Sourcing and BOM fit
The single-piece quantity unit and packaging quantity of 1 mean a multi-axis build must be ordered as N units of the same order code rather than a single bulk line — line items per axis on the PO. Because no holding brake is fitted and the protection class is IP54 without an oil seal, this variant suits dry cabinet-internal axes (feed rolls, small conveyors, light packaging) where the brake and sealing can be handled elsewhere in the drivetrain.