What the carton delivers for a S200 build
The 1FL2103-4AG00-0MC0 is a SIMOTICS S-1FL2 low-voltage servo from the 1FL2 family, rated 0.4 kW at 3000 rpm with a 1.27 Nm continuous torque — sized for the small-frame end of the SINAMICS S200 line where positioning axes, small feeders, and short-stroke slides sit. Supply is 200 V 3AC, shaft height 30 mm, plain shaft with N tolerance, encoder AM21 (21-bit absolute), and IP54 without an oil seal — meaning the motor body is dust- and splash-protected but the sealing arrangement excludes oil-resistant duty; that combination is what the drive-side S200 firmware expects for that axis class. No holding brake is fitted on this variant — for any axis that needs a fail-safe stop the kitting list must add a brake-equipped motor from the same shaft-height family rather than retrofit a third-party unit.
Kit completeness and what ships with the motor
Quantity unit is 1 piece, packaged in a 315 x 182 x 172 mm carton — a single-motor pack, not a multi-up. Product class C applies: the motor is built to order and cannot be returned against credit, so the BOM line must be confirmed before the PO drops. The mating connector side is the hybrid AM21 on the motor — power and signal share one plug body — which keeps panel wiring to a single cable run back to the S200 drive and cuts the typical two-cable mess on a small servo axis.
Lifecycle and the S200 sourcing window
Lifecycle stage is current and the part is listed as active — this is not a stocked catalog shelf item at the manufacturer; it is built to order against the BOM.