Frame, shaft, and what it physically lands as
The 1FL2103-4AG01-0HC0 is a SIMOTICS S-1FL2 servomotor in the 30 mm shaft-height frame, wound for a 200 V 3AC supply and rated 0.4 kW at 3000 rpm with a continuous torque of 1.27 Nm — the same figure is stamped as both M0 and Mn, which is the low-inertia signature of this family and means the motor holds rated torque from standstill through base speed without a torque-derate knee to worry about on a positioning axis. Mechanical interface is a plain shaft to tolerance N, no holding brake, IP65 protection class with an oil seal at the shaft exit, and a hybrid AS17bit feedback connector — that connector carries both the encoder lines and the power leads in one shell, which is what the 'hybrid' label means and is the only sanctioned way to wire a 1FL2 to a SINAMICS S200 without adapter harnesses.
Compliance paperwork and orderability
Compliance ledger carries RoHS conformity since 01-01-18, REACH Article 33 duty-to-inform against the current candidate list, and a clean export-control profile (AL:N / ECCN:N) — no dual-use declaration is triggered when this motor crosses a border. Listed lifecycle stage is current and product status is Active — the part is not on a phase-out or last-time-buy clock on the manufacturer record. Packaging footprint is 315.00 x 182.00 x 172.00 mm for a single-piece shipper — a useful reference when slotting the carton into an MRO spare cabinet next to a like-for-like replacement motor.
Where this motor drops into a line
A 0.4 kW, 3000 rpm low-inertia frame with IP65 oil-seal protection and no holding brake is the typical fit for auxiliary axes on a packaging, labelling, or small-format pick-and-place line driven by a SINAMICS S200 — short-cycle point-to-point moves where the brake is held by the drive's vertical-axis counterbalance or by a downstream mechanical lock, not by the motor itself.