0.75 kW, 2.4 Nm, 3000 rpm — what 1FL2 carries on the machine side of SINAMICS S200
The 1FL2104-2AF00-1HC0 is a Siemens SIMOTICS S-1FL2 servomotor in the 1FL2 family paired with SINAMICS S200 drives, rated 0.75 kW at 3000 rpm with a continuous stall torque M0 of 2.4 Nm and the same 2.4 Nm as rated torque Mn — i.e. a constant-torque frame sized for steady conveyor, index table and small-axis positioning duty rather than peak punches above rated. It runs on a 400 V 3AC supply, sits in shaft height 40 mm, ships with a keyed shaft to Tolerance N, carries an absolute encoder at 17-bit resolution, and is terminated via the hybrid connector — wiring lands on the matching SINAMICS S200 power and signal cable assemblies. Protection class IP54 seals the body for typical cabinet-near and light-washdown machine environments; the unit is built without a holding brake, so a back-up brake or vertical-axis counterweight must be engineered in by the panel builder where the load could sag on power-loss.
Frame, connection and mechanical fit
Shaft height 40 mm and the 1FL2 short-stack profile let the motor mount in the compact footprint typical of small-format assembly cells; the keyed shaft (Tolerance N) is the load-side interface a coupling or pulley is clamped to, and Tolerance N positions the key for a press-fit rather than a close-sliding fit. The hybrid connector on the cable end is the motor's single-cable interface — power, brake and encoder signals are bundled so only one cable route has to be planned between the cabinet and the moving axis. The mating cable set is the SINAMICS S200 MOTION-CONNECT line, not a generic industrial lead.
Compliance paperwork for a public-sector award
Per the specification, the motor has been RoHS-compliant since 01-01-18 and carries the current REACH Art. 33 duty-to-inform statement that Siemens publishes when a candidate-list substance is present above threshold — both pieces of evidence are needed to clear a tender compliance matrix. Export-control classification is AL: N / ECCN: N, so the part does not trigger an export licence on standard commercial export; this typically removes one line of paperwork on a cross-border tendered shipment where the award includes foreign sub-suppliers.
Order codes the storeroom will see
Group Code R220 and Product Group X0DK are the Siemens-internal cut lines a procurement system reads for reporting and contract routing — quoting and ordering against this MPN is unaffected, but the codes let an MRO ledger split motor spend into the right cost-centre bucket. Each unit ships as 1 Piece in packaging sized 382.00 x 222.00 x 240.00 mm — the carton is the unit of handling for receiving dock planning and forwarder booking, and the product carries Product class C (made-to-order, non-returnable against credit), so quantities should be firm before the order is released.