SIMOTICS S-1FL2 servo, 0.75 kW, paired to SINAMICS S200
The 1FL2104-2AG10-1SC0 is a SIMOTICS S-1FL2 low-inertia servomotor from the 1FL2 family designed to match the SINAMICS S200 drive platform, supplied as a single piece under product class C — built-to-order, non-returnable, non-reusable against credit. Electrical envelope: 200V three-phase supply, rated power 0.75 kW at a nominal speed of 3000 rpm, with standstill torque and rated torque both at 2.4 Nm — the 1:1 M0/Mn ratio tells the integrator this motor is sized for applications where continuous torque demand sits close to the peak, not for extended slow-speed high-torque dwells. Mechanical build: 40 mm shaft height, plain shaft with key and N tolerance, integrated holding brake for vertical-axis or hazardous-load retention, and an IP54 protected housing without an oil seal — the hybrid AS21bit single-cable connector carries power and the absolute encoder feedback in one assembly, simplifying cabinet routing on the S200 drive side.
Built-to-order class C and compliance footprint
Product class C means each unit is configured and produced to the order spec — the distributor channel quotes against the BOM line rather than pulling finished shelf stock, so lead time is governed by factory production scheduling rather than local inventory. Internal classification on the Siemens line is Group Code R220 within Product Group X0DK — these are the catalog keys to use when cross-referencing on the Siemens configurator or in the S200 drive's drive-cliq topology.
Sourcing posture and packaging
Lifecycle status is current and active — the 1FL2104-2AG10-1SC0 remains in normal production within the 1FL2 family, so a line-down replacement is sourced through the same OEM ordering channel rather than a discontinued-part broker. Single-piece quantity unit, packaged one per carton at 382 x 222 x 240 mm — a compact footprint that fits standard parcel handling, but because class C items are produced to order, multiples on a single RFQ are the practical way to amortise the configured production run. For a quotation against the BOM, the order code and the matching SINAMICS S200 drive designation should both be on the RFQ so the motor/drive pairing is confirmed at the same time — that is the closing step on the S200 platform before commissioning.