0.75 kW at 3000 rpm — what the headline torque buys you
The 1FL2104-2AG11-1MC0 is a SIMOTICS S-1FL2 servomotor in the 1FL2 family intended to pair with a SINAMICS S200 drive. Rated Pn=0.75 kW at Nn=3000 rpm, with both M0=2.4 Nm and Mn=2.4 Nm — stall and nominal torque are equal, which is the typical flat-torque profile a packaging or small-format machine expects across the speed range. Supply is 200V 3AC, so the cabinet feed needs the low-voltage 3-phase rail rather than 400V; on a packaging line fed from a 230/400V transformer this is the winding you wire to the S200's 200V class output. The 40 mm shaft height slots into the compact-machine end of the 1FL2 range, and the holding brake plus shaft-keyway combination is the configuration most machine builders specify for vertical-axis or indexing duty where the load must hold position with the drive disabled.
IP65 with oil seal — where this motor sits on the floor
Protection class IP65 with oil seal means the motor body is dust-tight and resists low-pressure water jets, with the shaft seal keeping cutting fluid or lubricant from migrating into the bearing housing. That makes the 1FL2104-2AG11-1MC0 a realistic fit for machine bases near coolant splash zones, washdown-adjacent conveyors, or any cabinetless mounting where the motor breathes factory air directly. The hybrid connector AM21bit is a single-cable solution carrying both power and the 21-bit absolute encoder feedback back to the SINAMICS S200 — one connector run instead of separate power and signal cables, which shortens commissioning and removes a known failure point on vibration-prone axes.
Production status for the BOM
The 1FL2104-2AG11-1MC0 sits in the current production lifecycle and the orderable unit is one piece with a single-piece packaging quantity.
Logistics footprint for receiving
Each unit ships in a 382.00 x 222.00 x 240.00 mm package — a single-motor carton that fits a standard small-parts shelf and does not need a dedicated pallet slot on inbound. For an OEM staging cells on a lean line, that footprint lets the motor go straight to the assembly bench from goods-in without an intermediate kitting step.