Match to SINAMICS S200 drives on the bench
The 1FL2105-2AF01-0HB0 is a SIMOTICS S-1FL2 low-inertia servo from the 1FL2 family sized for direct pairing with the SINAMICS S200 drive line — the motor nameplate, encoder type and shaft format on this code are the ones the S200 firmware expects at first commissioning, so substituting a 1FL2 variant from a different drive family usually forces a parameter re-import on top of the mechanical swap. Rated supply is 400 V 3AC with Pn = 1.5 kW, Nn = 3000 rpm, M0 = 5 Nm and Mn = 4.6 Nm; on a SINAMICS S200 the 400 V 3AC rail and the 1.5 kW power class are the matching slot, and the 5 Nm / 4.6 Nm torque envelope is what the drive's current controller is mapped to, so the motor's continuous-torque figure, not its rated speed, is the binding number for sizing the gearbox or checking accel headroom on a high-inertia load.
Shaft, feedback and sealing at the machine face
Mechanical package on this order code is shaft height 52 mm, plain shaft with Tolerance N, no holding brake, and an angular connector for the power and feedback cables; because there is no holding brake fitted, any vertical-axis application where the load must hold position with power removed needs an external mechanical brake or a different 1FL2 variant — the plain-shaft/no-brake build is intended for horizontal axes and for the packaging-and-conveyor class that the 1FL2 family targets. Feedback is the 17-bit absolute encoder in the AS angular connector option, and protection class is IP65 with oil seal; IP65 with the oil seal is the spec that decides whether the motor can sit near a gearbox with weeping lube or on a machine tool where cutting fluid reaches the housing — without the oil seal option the same shaft height derates to a drier duty cycle.
Lifecycle, order code and compliance paperwork
Compliance: RoHS conformity since 01-01-18, REACH Art. 33 candidate-list information provided, and the export-control classification is AL:N / ECCN:N with no special licence required for cross-border shipment; product class is 'made to order' — built per configuration, non-returnable and non-reusable as a generic spare — so the BOM line is a build slot, not an off-the-shelf shelf pick, and order entry is the point at which the configuration freezes.
Sourcing posture for the BOM line
Packaging is one piece per shipper, 432 x 222 x 240 mm, and quantity unit is one piece with packaging quantity one — single-piece shipments are the standard order form for a built-to-order servo, and quoting the BOM line means quoting against the configured code, not against a stocked SKU.