What the order code ships and how it pairs
The Siemens 1FL2203-2AF01-1MC0 is a SIMOTICS S-1FL2 low-inertia servo in the 1FL2 family, sized for 400 V 3AC operation on a SINAMICS S200 drive — the matching drive is the only documented pairing on the product description, so the motor is wired and parameterised for that controller out of the box. It is rated 0.2 kW (Pn) at a nominal speed of 3000 rpm, with both standstill torque (M0) and nominal torque (Mn) at 0.64 Nm — the equal M0/Mn figure is typical of a low-inertia frame where the motor can hold rated torque down to low speed without thermal derating. Mechanical build is shaft height 30 mm with a keyed shaft (tolerance N), a hybrid AM21 connector for power and feedback, no holding brake, and IP65 protection with an oil seal at the shaft exit — adequate for cabinet-internal mounting or light splash environments rather than direct washdown.
Why these ratings matter on the panel
The 0.2 kW / 0.64 Nm package targets small-format axes — indexing tables, light feeders, label applicators, small-format pick-and-place — where the 400 V 3AC supply is already present and the 30 mm shaft height fits the machine builder's standard frame. The AM21 hybrid connector carries both power conductors and the 21-bit encoder signals in one plug, so cabinet wiring is a single hybrid cable run to the SINAMICS S200 rather than separate power and signal lines — keeping the panel footprint tight and the EMC loop area short.
Codes, compliance, and how it is shipped
Siemens lists this motor under Group Code R220, Product Group X0DJ, in product class C — built-to-order items that cannot be returned against credit, so the RFQ should lock quantity, lead time, and cancellation terms before release. Lifecycle stage is recorded as current, and the unit ships as one piece in packaging sized 315.00 x 182.00 x 172.00 mm — consistent with a single-motor carton ready to slot into a panel-builder's spares shelf or a service truck.