What this motor drops into
The 1FL2203-2AF10-0HC0 is a SIMOTICS S-1FL2 servo from the 1FL2 family built specifically to pair with the SINAMICS S200 drive, so the cable set, electronic nameplate, and one-button tuning are already aligned at the system level — no firmware handshaking required at commissioning. On the nameplate the 400 V 3AC supply feeds a 0.2 kW (Pn) frame delivering a rated torque of 0.64 Nm (Mn) at a rated speed of 3000 rpm (Nn) with a stall torque M0 = 0.64 Nm, so the continuous and stall figures are matched — the motor is not a high-overload design, and sizing should treat 0.64 Nm as both the working and the standstill ceiling. The mechanical package is a 30 mm shaft height with a plain shaft (tolerance N), a holding brake fitted, and IP54 protection without an oil seal, which lands the motor inside standard cabinets or light-duty machine enclosures but out of washdown or food-grade zones where the sealing class would need to step up to IP65 or higher.
Encoder, connector, and drive pairing
Feedback is an absolute 17-bit single-turn encoder (AS17bit) brought out on the listed hybrid connector — the single-cable hybrid simplifies the panel-side wiring because the power cores and the encoder lines share one moulded cordset rather than running two separate drag-chain cables back to the cabinet. Because the motor is designated for the SINAMICS S200, the drive-side firmware auto-identifies the motor via the electronic nameplate and pre-loads the matching current and torque limits, which removes the manual parameter entry step that an older SIMOTICS-1FK/1FT retrofit would have required.
Lifecycle and compliance posture
Lifecycle is listed as current/active, so the part is in normal production rather than a last-time-buy window — orders against an RFQ land through the standard build cycle, and the product class is C (built to order, non-returnable), which is the usual posture for a configured servo and is worth flagging internally before a blanket blanket-order PO is raised. RoHS compliance is declared since 01-01-18 and REACH Article 33 information is available on the manufacturer record, so the motor clears the substance-restriction gates for installation in equipment destined for the EU market without an exception note in the technical file.
Logistics and quoting posture
The product ships as one piece per package quantity in a 315 x 182 x 172 mm carton, so small-lot MRO spares and full multi-axis build kits both fit the same handling profile — no oversize-pallet surcharge applies for a single motor.