Sizing the S200 axis around 0.2 kW and 0.64 Nm
The 1FL2203-2AF11-1HC0 is a SIMOTICS S-1FL2 low-inertia servo from the 1FL2 family sized for the SINAMICS S200 drive line, with a 400 V 3AC supply, rated power Pn of 0.2 kW, rated speed Nn of 3000 rpm, and matched standstill and rated torque figures of 0.64 Nm — so M0 equals Mn on this frame, a profile that suits constant-torque conveyor, indexing table and small Z-axis duty rather than high-inertia spindle work. Shaft height is 30 mm with a keyed shaft to tolerance N and a holding brake fitted as standard, giving the holding torque needed for vertical-axis applications where the load must stay put when the drive enable drops. The motor carries an integrated AS17-bit encoder and exits through a hybrid connector, which means the power and feedback share one cable assembly on the S200 side — plan the cabinet gland layout for the hybrid cordset rather than separate power and signal entries. The IP65 rating with oil seal on the shaft end means the body tolerates plant-side splash and coolant mist around a wet machining or washdown-adjacent cell, as long as the cable entry itself is sealed to the same level on installation.
Lifecycle stage is logged as current and the brand status confirms the part is active, so a line build quoting this code into a new design is naming the same motor the factory is shipping today. Product class is logged as made-to-order with no return-for-credit pathway, which is the standard Siemens posture for configured servo motors — plan the order quantity to match the BOM rather than treating spares as returnable. Substance compliance is current: RoHS conformity is recorded since 01-01-18 and REACH Art. 33 candidate-list information is supplied with the product, which closes the substance-restriction clause in most EU and EU-exporting panel builds without further paperwork. Export classification shows AL:N and ECCN:N, so routine commercial shipments do not require an export-control licence on the part itself — still verify the end-use and destination per your own compliance gate.
Packaging and unit-of-order detail for indirect-spend planning
The unit of order is a single piece and the packaging quantity matches that single piece, with carton dimensions of 315 x 182 x 172 mm — relevant when the receiving dock needs to confirm carton space before a release ships. Group code R220 and product group X0DJ on the ordering record are how Siemens routes the line internally and how a punch-out catalog will index this SKU; if your tail-spend catalog maps against these codes, this order code drops cleanly onto the preferred-supplier flow rather than becoming a one-off requisition.