Match the drive before the panel
The 1FL2203-2AG00-1HC0 is a SIMOTICS S-1FL2 low-inertia servo from the family explicitly matched to the SINAMICS S200 drive line, so the auto-tuning blocks, motor ID tables and encoder scaling are sized for each other out of the box — pick the drive first, then pick this motor order code against it. It runs on a 200 V 3AC supply rail at a rated power of 0.2 kW with 3000 rpm nominal, and the continuous and stall torques both land at 0.64 Nm — useful symmetry for tuning, because the thermal model doesn't shift when the motor sits at standstill vs running speed at that load.
Mechanical and feedback package
The 30 mm shaft height puts this in the compact end of the 1FL2 line — a flange integrator can plan a small mounting footprint and short coupling stack, which lowers the inertia downstream of the rotor and helps the velocity loop stay quiet. Feedback is the AS17bit absolute single-turn encoder, so the drive closes position and velocity on a high-resolution signal; that resolution is the floor on the loop bandwidth you can chase in tuning, and it is what makes the motor behave predictably on a millimetre-scale pick-and-place or indexing axis. Output is a shaft with key, tolerance class N, and the body carries no holding brake — if the application needs a fail-safe stop after power loss, that selection belongs in a different 1FL2 option, not this order code.
Sealing, connector, and what the IP54 rating covers
Protection class IP54 without an oil seal: the housing resists splashing and dust ingress, which suits a clean cabinet or a lightly soiled machine envelope, but this build explicitly excludes the oil-seal option — a gearbox or gearhead side that can weep oil onto the shaft needs a different variant. The hybrid connector carries power and feedback signals in one shell, so cabinet-side wiring is a single cable run back to the SINAMICS S200 — fewer glands, fewer conductors to terminate, and a single keyed mate during commissioning.
Procurement codes and shipping envelope
The line is listed as active, so 1FL2203-2AG00-1HC0 is on the current build schedule and not in a phase-out window — but it is built to order and not returnable against credit, which means a panel builder should size the order quantity to the actual axis count rather than treat it as catalogue stock. Quantities ship one piece per orderable unit, packaged to roughly 315 × 182 × 172 mm — small enough to land on a standard courier consignment alongside a drive, no special handling bracket required. Compliance trail: RoHS conformity since 2018-01-01, plus the REACH Article 33 duty-to-inform obligation for candidate-list substances — the traceability file a quality inspector asks for is the standard Siemens compliance pack, not an exception.