SIMOTICS S-1FL2, 30 mm shaft, paired to SINAMICS S200
The Siemens 1FL2203-2AG10-1MC0 is a SIMOTICS S-1FL2 low-voltage servomotor from the 1FL2 family built to run on a SINAMICS S200 drive, so the motor, cable, and drive system are sized as one matched set rather than mixed across vendor lines. The low-inertia 30 mm shaft-height frame lands in the small-format end of the family — typical fit is feeder, indexing, and small-format positioning axes where a 0.64 Nm continuous / 0.64 Nm rated torque package is enough to drive the load without oversizing the cabinet. 200 V 3AC supply, Pn = 0.2 kW, Nn = 3000 rpm, M0 = 0.64 Nm and Mn = 0.64 Nm are the headline ratings carried on the product description — the equal standstill and rated torque tells the integrator this frame is tuned for short-cycle accel/decel rather than continuous high-torque duty. Single-turn AM21bit encoder back to the drive closes the position loop; the holding brake holds the axis when the DC bus drops.
Mechanical envelope and panel-side mounting
Carton dimensions of 315 x 182 x 172 mm set the bench footprint the unit arrives in — small enough to bench-commission next to the drive before the panel cutouts are finalized. The housing is rated IP54 without an oil seal, so the frame handles dust and light splash in a typical enclosure but is not the right choice for a washdown or food-grade cell; an oil-seal variant would be needed if the process side of the guard runs wet. Shaft height 30 mm with key and tolerance N, plus the hybrid AM21bit connector at the terminal box, is the standard small-frame 1FL2 build — flange mounting onto a gearbox or a small linear actuator is the normal integration pattern. The holding brake is wired through the same hybrid connector so there is one cable to dress back to the drive, not a separate brake lead.
Lifecycle, traceability, and document pack
Compliance trail covers RoHS conformity since 01-01-18 and REACH Article 33 duty-to-inform per the current candidate list — both fall under the documentation pack a qualifiable system is expected to carry. Export-control markings read AL:N / ECCN:N, which means no special export license is triggered for routine cross-border shipments. Group code R220 and product group X0DJ are the internal Siemens classification keys carried on the nameplate and on the packing slip — they line up the motor to the right price list and the right certificate folder, and they should be read back into the PO line so the receiving inspection matches the exact variant, not a near-neighbour in the 1FL2 family.
Sourcing posture for this order code
Packaging quantity is one piece per carton and the unit is built to order, so there is no economic advantage to batching multiple units into one RFQ — each motor is a separate production line entry. For a panel builder, that argues for releasing the motor line of the BOM ahead of the drive so the matched pair arrives on the same dock window.