Which drive side picks this motor
The 1FL2203-4AF00-1SC0 is the low-inertia SIMOTICS S-1FL2 servo in the 30 mm shaft-height frame, sized for SINAMICS S200 — meaning the drive, controller, and motor are paired inside one matched toolchain rather than mixed across families. Rated output is 0.4 kW at 3000 rpm with a continuous torque of 1.27 Nm (M0 = Mn = 1.27 Nm), so the motor delivers its stall torque all the way to rated speed without a torque-step derate — the figure a sizing calculation actually reads off the nameplate.
Electrical envelope and mechanical fit
Supply is 400 V three-phase, which puts the motor on the standard industrial three-phase bus rather than a single-phase 230 V tap — a panel builder wiring this against a SINAMICS S200 line-side supply should treat it as a balanced three-phase load. Mechanical interface is shaft height 30 mm with a keyed shaft (tolerance N) and no holding brake; the IP54 protection class excludes oil-seal sealing, so the motor is suited to general industrial environments but not washdown or food-grade zones that demand IP65 or higher. The hybrid connector and 21-bit feedback close the loop back to the SINAMICS S200 drive without a separate battery box on the motor — the encoder runs absolute from the drive side, which keeps commissioning to a one-cable power-plus-feedback hookup.
Compliance and administrative codes
Group Code R220 and Product Group X0DJ identify the line inside Siemens' own product taxonomy, useful when cross-checking the order code against the packing list or a Siemens commercial invoice during goods-in.