Where this motor drops in the cabinet
The 1FL2203-4AF10-0SC0 is a SIMOTICS S-1FL2 low-inertia servomotor sized for the 400 V 3AC, 0.4 kW slice of a SINAMICS S200 axis — Pn = 0.4 kW at Nn = 3000 rpm, with M0 = Mn = 1.27 Nm, so the continuous and standstill torque figures are equal and the drive can be commissioned on the rated point without a derate window. It carries a holding brake for vertical-axis holding and an IP54 housing without an oil seal, which suits general industrial enclosures but rules out direct washdown mounting — the sealing spec is for dry factory floor, not wet-process lines.
Feedback, shaft, and panel-side wiring
Feedback is a 21-bit absolute single-turn encoder wired through the hybrid connector, so positioning comes up absolute on first power-up with no homing run needed across the SINAMICS S200 commissioning sequence. Shaft height is 30 mm with a plain shaft, tolerance N, meaning no key and no feather keyway — a clamp coupling or bellows coupling takes the misalignment budget, and the BOM cannot reuse a keyed coupling from a previous axis without rework.
Lifecycle and compliance posture
Lifecycle status is recorded as current on the manufacturer line, so this is an active-production order code rather than a last-time-buy — there is no LTB cutoff or PCN pointing to a mandatory successor on the record.
Sourcing through the order desk
Product class is built-to-order with no return-for-credit pathway, so the order goes in against a confirmed quantity and ships as a single-piece unit in the 315 x 182 x 172 mm shipper — no surplus-channel substitution, no decanting from bulk stock.