1FL2203-4AG10-0SC0 — 0.4 kW SINAMICS S200 servo with holding brake
The 1FL2203-4AG10-0SC0 is a SIMOTICS S-1FL2 low-inertia servo in the 1FL2 servomotor family, sized to the SINAMICS S200 drive — Group Code R220, Product Group X0DJ. Continuous rating on the nameplate is 0.4 kW at 3000 rpm with a 1.27 Nm stall and rated torque, so it covers the typical small-format positioning axis (feed, index table, small gantry) where the motor has to start under load and hold position with the brake engaged. The build is a 30 mm shaft-height frame with an AS21-bit hybrid encoder, plain shaft (tolerance N), and an IP54 enclosure without oil seal — a dry, indoor panel-side duty, not a washdown or outdoor mount.
Holding brake and matching drive
An integral holding brake is part of the order code suffix (-0SC0), so the axis is mechanically clamped at standstill without an external brake — the wiring job drops to the SINAMICS S200 hybrid connector on the motor side and the drive's brake terminal on the cabinet side. Because the encoder is the AS21-bit single-cable hybrid variant, the motor and drive are a matched set — pairing this 1FL2 with anything other than the SINAMICS S200 family means the encoder protocol does not line up and commissioning fails at first connect.
Lifecycle, packaging, and compliance paperwork
RoHS compliance has been in force since 01-01-18, and the part carries the REACH Art. 33 duty-to-inform disclosure, which means the shipment arrives with the standard EU substance-restriction declarations for panel-builder documentation. The factory ships this as a single piece in a 315.00 x 182.00 x 172.00 mm pack on a made-to-order basis, so it is not returnable for credit — order quantity should match the spares package, not a trial-and-error bench ask.