Shaft height 30, 0.4 kW: where this motor sits in the line
The 1FL2203-4AG10-1HC0 is a SIMOTICS S-1FL2 low-inertia servo motor from the 1FL2 family sized for SINAMICS S200 drives, delivering 0.4 kW at a 200 V 3AC supply with a rated speed of 3000 rpm and 1.27 Nm on both the continuous and rated torque figures. Shaft height 30 mm puts it at the small-frame end of the 1FL2 line, where it covers indexing tables, small packaging axes, and auxiliary feeders rather than the higher-torque main spindle role served by larger 1FL2 frames. The motor ships with a holding brake and a keyed shaft (tolerance N), uses a hybrid connector for power and signal, and is rated IP54 without an oil seal — a configuration aimed at clean cabinet-side panels where the cable gland stays inside the enclosure. It carries a single-turn AS17 bit encoder for commutation with the matching S200 drive.
Active lifecycle, made-to-order: what that means for the BOM
Lifecycle status is listed as active / current, and the part is built to product class C — produced to order, not re-usable or returnable for credit. For a project buyer that means a unit hits the line only after the order is placed against Siemens; there is no distributor shelf-pull that can be re-absorbed into inventory if a slot on the BOM falls through, so the order quantity and the install date have to be aligned at RFQ time. Each unit ships as 1 piece in a 315.00 x 182.00 x 172.00 mm pack and is flagged for unrestricted export under AL:N / ECCN:N, which keeps cross-border project shipments and commissioning spares moving without an additional licence gate.
Compliance and documentation on record
RoHS compliance has been in force since 01-01-18 for this order code, and the part is covered by the REACH Article 33 duty-to-inform regime, with the current candidate-list information issued through the manufacturer. For a project dossier that combination clears the EU substance-restriction gate without a custom deviation note.