0.4 kW continuous at 3000 rpm, sized for the S200 cabinet
The 1FL2203-4AG11-0HC0 is a SIMOTICS S-1FL2 low-inertia servo rated 0.4 kW continuous at a rated speed of 3000 rpm, with 1.27 Nm continuous torque and an identical 1.27 Nm standstill figure — meaning the motor holds rated torque down to zero speed without folding back into field-weakening territory until well past the operating point.
Loop integrity and feedback resolution for positioning axes
The 17-bit absolute encoder single-turn keeps the position loop deterministic to the cycle and well below the backlash budget of a 5-axis machining center. With M0 = Mn at 1.27 Nm, acceleration headroom is bounded by the drive's current limit rather than the motor's thermal envelope — the loop stays clean as long as the S200 is dimensioned to push that current without saturating. The hybrid connector bundles power and signal in one plug, so cabinet-side wiring is one cable per axis instead of two. With the holding brake wired through the same connector, no separate brake rectifier or extra gland is needed at the motor — clean for repeatable shot after shot on repetitive CNC cycles.
Lifecycle, compliance, and order administration
RoHS compliance is in force since 01-01-18 and REACH Art. 33 candidate-list information is published by the manufacturer for downstream disclosure. Export control flags AL:N / ECCN:N indicate no special licensing gate for typical destinations; that paperwork still travels with the shipment. Group code R220 / product group X0DJ are the administrative handles inside the Siemens ordering system that the buyer needs to match against the PO.
Procurement posture for a line-down spare
Lead time and volume pricing are confirmed at RFQ rather than read off a shelf — the right move for an integrator locking a multi-axis S200 panel build or an MRO planner stocking a 0.4 kW spare for a known line.