What the ratings mean for axis sizing
The 1FL2204-2AF00-0MC0: The 0.75 kW rated power at 3000 rpm with a matched 2.4 Nm stall torque defines a compact servo axis suited for pick-and-place, labelling, and conveyor indexing in packaging lines — the kind of low-inertia axis that accelerates quickly and holds position under varying load without overshooting. IP54 on the motor body means the housing seals against dust and splashing water from any direction, but the shaft bore is open — no oil seal fitted on this variant. In a bottling line with washdown cycles, the plain shaft side will need a separate bellows boot or bearing isolator to protect the shaft seal from moisture ingress. The AM21bit hybrid connector on the motor end packages both the encoder feedback and motor power conductors into a single mated harness run — clean cable management for single-cable axis setups on SINAMICS S200, but it means the mating cable to the drive must be the correct SINAMICS S200 motor cable type.
Built to order — what the sourcing posture means
The part carries Product Class C: manufactured to order, with no reuse, return, or credit policy. That is a hard BOM-commitment gate — you are not ordering from stock; you are committing to a build against a confirmed purchase order. Lead time and minimum quantity are confirmed at RFQ before any PO is placed. Sourced to order through independent distribution, quoted against BOM quantity. The 1FL2204-2AF00-0MC0 carries an Active lifecycle status from Siemens, so it is a current-production part — the supply question is lead time and lot traceability, not obsolescence risk.
Compliance and the 40 mm shaft frame
No UL or IEC safety rating is cited on this listing, which is typical for OEM servo motors evaluated at the machine-build level rather than the component level. Shaft height of 40 mm sets the DIN-rail or foot-mount frame size — compatible with standard 40 mm servo brackets, NEMA 17 equivalent mounts, and most SINAMICS S200 cabinet drive combos. The plain shaft with N tolerance is the standard production run fit — no keyway or flange-specific feature that would require a non-standard coupling.