SIMOTICS S-1FL2 servo motor for SINAMICS S200
The 1FL2204-2AF11-1HC0 is a SIMOTICS S-1FL2 permanent-magnet servo motor in the Siemens motion-control ecosystem, paired specifically with the SINAMICS S200 drive. The 40 mm shaft height and compact frame sit at the smaller end of the 1FL2 family, making this unit suited for packaging machinery, textile equipment, and general automation axes where the S200 drive is already the motion controller of record.
400 V 3AC, 0.75 kW, 3000 rpm — what the ratings mean for the axis
Rated 0.75 kW mechanical output at 3000 rpm on a 400 V three-phase supply, the motor delivers a continuous standstill torque of 2.4 Nm and a rated torque of 2.4 Nm — the same figure across both conditions means the motor holds its torque rating at zero speed, which is the holding-brake operating window. The matching SINAMICS S200 drive supplies the vector control and encoder feedback loop; the AS17bit absolute encoder provides single-turn position information over the hybrid connector so the drive resolves rotor position on power-up without a homing run — a meaningful advantage in indexing and pick-and-place cycles where every homing routine adds cycle-time overhead.
IP65 with oil seal — sealed barrel for industrial duty
IP65 with oil seal means the motor barrel is protected against dust and low-pressure water jets, and the shaft oil seal guards the bearing cavity against lubricant ingress from the driven machine — suitable for environments with coolant mist or washdown splash, but the hybrid connector itself must be mated and locked before the IP65 seal is valid at that interface.
Integrated holding brake and shaft detail
The integrated holding brake is a spring-set, electrically released mechanism that holds the motor shaft static when the drive is de-energised — the brake does not provide dynamic braking during a fault stop, it simply removes power and springs into the held position. Shaft key with tolerance N is fitted, meaning the key slot follows standard commercial shaft tolerances, compatible with standard collets and couplings in the 40 mm frame size.
Product class C — manufactured to order
The listing carries Product class C: products manufactured or produced to order, which cannot be reused, re-utilised, or returned for credit. This is not a stocked line held in ready inventory — units are built to the purchase order, so lead times are tied to Siemens manufacturing schedules and confirmed at RFQ rather than against a live stock figure. RoHS compliance is confirmed since 01-01-18, and REACH Article 33 duty-to-inform substances are disclosed on the current candidate list — compliance documentation for Siemens S-1FL2 parts is available through the standard Siemens RoHS/REACH portal or on request.