Sizing the 1FL2204-2AG01-0SC0 on the SINAMICS S200 rack
The 1FL2204-2AG01-0SC0 is a SIMOTICS S-1FL2 low-inertia servomotor sized at 0.75 kW with a rated speed of 3000 rpm and matched standstill/rated torque of 2.4 Nm, so it lands on the same shaft-height-40 mm mounting footprint used across the S200 axis family. It belongs to the 1FL2 servomotors for SINAMICS S200 product family — the motor is built specifically as the rotating half of an S200 axis, with the hybrid connector, 21-bit absolute encoder (AS21bit) and IP65 oil-seal body all matched to the drive's firmware and connector map.
Where the 0.75 kW / 2.4 Nm rating drives the decision
200 V 3AC supply with a 0.75 kW Pn and 3000 rpm Nn — the 0.75 kW continuous rating is the figure that gates the axis sizing, not the standstill torque, so any application above roughly 2.4 Nm continuous at base speed needs the next frame up. M0 = 2.4 Nm equals Mn = 2.4 Nm on this winding — standstill and rated torque match, which means no constant-power speed range above base speed; pick a higher-speed variant in the same shaft height if the cycle needs field-weakening headroom. Plain shaft, tolerance N, no holding brake — without a holding brake the motor will freewheel on power loss; vertical axes either need a mechanical brake elsewhere in the drivetrain or a different 1FL2 variant ordered with the brake option.
Deployment notes — cabinet, sealing, encoder
IP65 with oil seal means the housing tolerates washdown and coolant splash around the shaft entry — the oil seal is the wear item, so specify the replacement seal kit into the MRO spares alongside the motor, not just the motor itself. The hybrid connector carries both power and the 21-bit absolute encoder signal — a single cable run back to the SINAMICS S200, so the cabinet-side mating connector and cable assembly must be ordered to match, not cross-wired from a third-party loom.
Lifecycle and product class
Siemens lists this order code as currently active, and the product is classified as made-to-order — produced per order, not returnable for credit, so lead time is governed by Siemens' configured-order pipeline, not shelf stock. RoHS-compliant since 01-01-18 with REACH Art. 33 disclosure carried and no export-control flags (AL:N / ECCN:N) on the listing — the compliance paperwork trail is straightforward for EU and most non-restricted destinations.
Packaging and admin codes
Siemens ships the 1FL2204-2AG01-0SC0 one piece per package at 382.00 x 222.00 x 240.00 mm, under Group Code R220 / Product Group X0DK — those are the internal codes to quote when phoning Siemens order desk or matching the PO line.