200 V 3AC, 0.75 kW on a 40 mm shaft height
The Siemens 1FL2204-2AG11-0SC0 is a SIMOTICS S-1FL2 low-inertia servomotor in the 1FL2 family sized for the SINAMICS S200 drive line, with a 200 V 3AC supply, rated power of 0.75 kW, rated speed of 3000 rpm, and standstill/rated torque of 2.4 Nm — meaning the motor holds full torque down to zero speed and delivers the same figure at base speed, so sizing is matched at the rated point rather than at a peak. It carries an integrated holding brake, a 21-bit AS encoder (single-turn absolute), a plain shaft with tolerance N, and the hybrid connector variant of the family — the brake is the mechanism that holds the axis during a vertical-stop or power-loss event, while the 21-bit feedback closes the position loop on the S200 at the resolution needed for indexing and registration moves common in packaging machinery.
IP65 with oil seal and 40 mm frame
Protection class is IP65 with oil seal on a shaft height of 40 mm — the oil seal excludes coolant and lubricant splash that an open shaft would ingest, which is the typical mounting environment for this frame size on packaging and handling lines where gear oil or washdown mist is present at the gearbox output. The matched drive on the other end of the hybrid connector is the SINAMICS S200 — pairing the motor to a drive outside the S200 family is not supported in this code, so the BOM line locks the drive selection to the S200 platform.
Lifecycle, compliance, and order characteristics
Product class is C (products manufactured to order that cannot be reused or returned against credit), the quantity unit is 1 Piece, and packaging quantity is 1 — every order ships as a built-to-order unit, which is the procurement reality for S-1FL2 motors and sets expectations on lead time and return policy at quote. Compliance posture: RoHS substance restrictions are declared since 01-01-18 and REACH Art. 33 candidate-list information is published via the Reach Information reference — no ECCN/AL flag (both N), so no special export licence is triggered for typical destinations.
Group code R220, product group X0DK
The Siemens internal ordering codes are Group Code R220 and Product Group X0DK — these are the identifiers a procurement or material-control system reads off the order acknowledgement when reconciling the line against the PO and the engineering BOM.