Built for the SINAMICS S200 cell
The 1FL2204-2AG11-1SC0 is a SIMOTICS 1FL2 low-inertia servomotor in the 200 V 3AC class, rated 0.75 kW at 3000 rpm with a 2.4 Nm continuous torque and a 2.4 Nm stall torque, sized for the SINAMICS S200 drive platform. It carries a shaft height of 40 mm, a keyed shaft with N tolerance, an integrated holding brake, and a 21-bit hybrid connector for power and feedback in a single cable — the connector choice keeps the cabinet-side wiring to one cordset per axis. Production status is Active under Siemens lifecycle tracking, and the product is classified as a built-to-order item that cannot be returned for credit, which means lead time is governed by factory scheduling rather than shelf stock.
Rating envelope and mechanical fit
At 200 V 3AC the motor delivers 0.75 kW with a 3000 rpm rated speed, matching the 200 V SINAMICS S200 input class — a 400 V class drive cannot be used with this winding. The matching drive line called out by the manufacturer is the SINAMICS S200, so the controller-side parameters, encoder protocol, and cable set all need to be the S200-native variants, not a generic V90 or S210 harness. The housing carries IP65 protection with an oil seal at the shaft pass-through, which is the right rating for a machine interior where cutting fluid or lubricant mist reaches the motor face but the unit is not directly hosed down. A plain IP64 or unsealed servo would be a poor substitute in a wet machining cell; conversely, an IP67 washdown-rated servo is over-specified here. The holding brake is built into this variant, which is what most vertical-axis and indexing applications need to hold position when the drive is powered down. If the BOM calls for a brake-less version, the dash suffix has to be checked — a same-frame 1FL2204 with a different option code ships without the brake.
Sourcing, lead time, and code-line fields
The part sits in Group Code R220 and Product Group X0DK inside the Siemens configurator hierarchy, and it is a 1 Piece sellable unit packaged one per box at 382.00 x 222.00 x 240.00 mm. Because product class C applies, every order is a fresh factory build with no return-for-credit path, so the procurement decision is really a question of how the lead time fits the project schedule before a PO is cut. Substance compliance is confirmed against the RoHS directive since 01-01-18, and the part is covered by the REACH Article 33 candidate-list disclosure obligation; export control is AL:N / ECCN:N, which means no special license is needed for the standard commercial shipment path. Sourcing through independent distribution, the typical pattern is to quote against the requested quantity and confirm the factory build slot at RFQ rather than to promise same-day pull from local stock.