Where this motor lands on the machine
The 1FL2204-2BF01-0HC0 is a SIMOTICS S-1FL2 low-inertia servomotor sized for the SINAMICS S200 drive family — a 400 V 3AC, 0.75 kW continuous rating with a rated speed of 3000 rpm and 2.4 Nm continuous torque, so it covers the mid-range point-load zone where you need dynamic response without oversizing the cabinet feed. Built around a 40 mm shaft height with a plain shaft (tolerance N) and no holding brake, this is the variant you reach for when the axis already has an external brake or gravity is not a concern at standstill — the hybrid connector keeps the power and feedback wiring in a single mated plug.
Ratings decoded for the BOM line
400 V 3AC supply with 0.75 kW nameplate and 2.4 Nm continuous torque at 3000 rpm means the motor delivers its full rated power at base speed — check the application S1 duty cycle and the S200 drive's continuous current limit against the motor's rated current before sizing the drive's overload headroom. Protection class IP65 with oil seal confirms the motor body and shaft exit resist coolant splash and oil mist typical of light machining and packaging cells — the seal is at the rotating interface, so specify a dry-running seal kit if the axis sits in a cleanroom where oil contamination is a no-go. The 17-bit absolute encoder feeds position back to the S200 drive on a single hybrid cable — multi-turn absolute position survives power cycles, so the machine does not need to home on every restart.