Active SIMOTICS S-1FL2 servo for the SINAMICS S200 line
The 1FL2204-2BF11-0SC0 sits in the SIMOTICS S-1FL2 family of low-inertia servomotors designed to pair with the SINAMICS S200 drive platform, carrying an active lifecycle status and a Product class designation that means the unit is built to order rather than stocked as a returnable catalog item. Configured for 400 V 3AC supply at Pn 0.75 kW and Nn 3000 rpm, with M0 2.4 Nm and Mn 2.4 Nm, the motor delivers continuous torque equal to its stall figure — a useful tell that the winding is sized for steady-state motion in the low-kW class rather than short bursts at higher ratings.
Mechanical and connection package
Built on a 40 mm shaft height frame with a plain shaft (Tolerance N) and an integrated holding brake, the unit ships with the hybrid connector variant that carries both power and signal through a single mating face — the practical effect on the panel side is one cable gland per motor instead of two, which matters in compact machine layouts where the cabinet run is tight. Protection class IP65 with oil seal covers the housing and the shaft entry for factory environments where coolant mist and cutting oil are present; combined with the AS21-bit absolute encoder, the motor closes the position loop to the SINAMICS S200 with single-cable hybrid connectivity rather than separate resolver and power leads.
Compliance and paperwork trail
Export classification lands at AL:N / ECCN:N, so the unit ships without an export-control licence gate in most commercial destinations; this keeps cross-border MRO spares moving without the extra paperwork layer that hitches higher-classified motion components.
Handling and logistics notes
Sold one piece per Quantity Unit with packaging dimensions of 382 x 222 x 240 mm — the carton is sized for a single motor with foam, not a multi-pack, so a small MRO shelf footprint per unit and a one-piece-per-order line on the BOM keep the storeroom count tidy.