0.75 kW continuous, 2.4 Nm — what this motor delivers
The Siemens 1FL2204-2BG01-1HC0 is a SIMOTICS S-1FL2 low-inertia servo motor from the 1FL2 family, sized for 0.75 kW continuous shaft power at a rated speed of 3000 rpm with both standstill torque M0 and rated torque Mn of 2.4 Nm — meaning the motor holds full rated torque down to zero speed without field weakening, so positioning axes don't sag under static load. It runs on a 200 V three-phase supply, is built on a 40 mm shaft-height frame, and carries an AS-interface hybrid connector plus a 17-bit absolute encoder — a typical SINAMICS S200 drive pairing where the encoder feedback rides the same cable as the power, so cabinet wiring stays to a single hybrid lead per axis.
IP65 with oil seal, keyed shaft, no holding brake
Protection class IP65 with oil seal makes this 1FL2204-2BG01-1HC0 suitable for machine cabinets and light-washdown environments where coolant mist and cutting oil are present — the sealing ring sits at the shaft exit, not on the housing thread, so the rating follows the seal installation. The shaft is supplied with a key and tolerance N, and there is no holding brake on this variant — fine for vertical axes that hold position through the drive's regenerative loop or for horizontal axes where an external brake isn't needed; pick a brake-equipped variant if the application must hold position with the drive unpowered.
Lifecycle: active, made-to-order, non-returnable
Product class C applies: the unit is manufactured to order and cannot be returned for credit, so confirm shaft height, encoder type, connector style and brake option against the BOM before release — substitutions cost a full reorder cycle.
Sourcing posture for 1FL2204-2BG01-1HC0
Stock holding on this 1FL2 code is lot-specific and confirmed at quote time — independent distribution sources genuine OEM production units with full traceability, and lead time for a single-piece order against the BOM is provided with the RFQ response rather than as a standing number.