1 kW at 3000 rpm — what the spec line commits to
The Siemens 1FL2204-4AF10-1HC0 is a SIMOTICS S-1FL2 servo motor in the 1FL2 family sized for the SINAMICS S200 drive platform, with 1 kW rated power at 400 V three-phase, 3000 rpm rated speed, and equal 3.2 Nm for both M0 stall and Mn rated torque. Matched stall and rated torque tells the integrator the motor holds full torque down to zero speed — the duty profile typical for indexing, pick-and-place, and feed axes where the cycle pauses in the move. Shaft height is 40 mm, which sets the flange footprint against the driven load and the machine's gearbox or coupling choice; the 17-bit hybrid connector and integral holding brake keep the wiring harness and the vertical-axis retention in the same shipment. IP54 enclosure without oil seal places this motor in dry, dust-screened cabinets and machine interiors — it is not a washdown or food-grade shaft feed. Where a panel builder must route a shaft through an enclosure wall, the IP54 rating dictates the sealing strategy at the gland.
Drive pairing, feedback, and shaft details the BOM must capture
The motor carries an absolute encoder (17-bit AS) and a hybrid connector, so the encoder protocol and the power/feedback pinout are locked to the matching SINAMICS S200 drive listed on the same ordering line — ordering the motor against a different drive will require confirming the cable set separately. Tolerance N shaft with keyway is the standard press-fit-plus-key power transmission; a keyed shaft is not a slip-fit, so any panel-side alignment has to account for a mechanical key registration during motor mounting.
Lifecycle stage, product class, and the documentation trail
Lifecycle stage is recorded as current and product status is Active on the manufacturer's record, so the part is in production rather than a last-time-buy or NRND line. The product class field is the manufacturer's make-to-order note — this motor is built against a specific order, it is not a stocked shelf item, and it cannot be returned against credit. RoHS compliance is documented from 01-01-18 and the manufacturer publishes REACH Article 33 candidate-list information — both are baseline entries every EU-bound shipment will be asked to produce, and the export-control classification is dual-use 'N' (AL:N / ECCN:N), which keeps this part out of the re-export paperwork pipeline.
Shipping and pallet geometry for the cross-border order
The factory packaging is one piece per Quantity Unit in a 382.00 x 222.00 x 240.00 mm carton — a single-axis replacement fits inside a standard parcel envelope class, but a multi-axis build ships as multiple cartons (one piece each per), so duty and freight quotes scale linearly with the quantity on the order, not the carton count.