What pairs with the SINAMICS S200
The 1FL2204-4AF11-0MC0: The part is a SIMOTICS S-1FL2 low-inertia servomotor from the 1FL2 family, built to feed the SINAMICS S200 drive side, with 1 kW rated power at 3000 rpm and a continuous/stall torque of 3.2 Nm at a 400 V 3AC supply rail — so the motor sizing, brake logic, and encoder feedback line up with the S200 without external scaling blocks. Lifecycle is current on the Siemens record, and the ordering code is product class C (built-to-order, non-returnable), which is the expected class for a configured servomotor — quote it into the BOM by configuration, not by shelf-pull.
Mechanical envelope and feedback
Shaft height 40 mm with a plain shaft, tolerance N, and a holding brake — the brake lands on the B-side of the BOM line and is wired through the same hybrid cable, so the kit lands with one power/feedback run rather than a separate brake lead. Feedback is 21-bit absolute (AM21DQC equivalent per the S-1FL2 datasheet family), brought out on a hybrid connector that carries both the encoder lines and the power — confirm the mating connector is on the drive-side accessory list before the panel is wired, because the hybrid shell is the single point that has to match between motor and SINAMICS S200. Protection class is IP65 with oil seal, so the motor survives coolant splash and light washdown typical of a machine-tool or packaging-line enclosure — but it is not IP67, so a direct hose-down zone needs an enclosure or a higher-rated frame.
Kit completeness for a swap-out
Carton footprint is 382 x 222 x 240 mm and ships as one piece — the hybrid connector is on the motor body, so the carton should contain the motor, the brake leads terminated at the connector face, and the rating-plate documentation; there are no separate resolver or fan accessories on this 40 mm shaft-height frame to chase down. Group code R220 and product group X0DK are the admin slots the order will be booked against — keep them on the PO line so receiving can reconcile the carton against the configured code without opening the box.
Compliance and export posture
RoHS compliance is declared since 01-01-18 and REACH Art. 33 candidate-list information is published by Siemens, so the declaration pack for an EU shipment is straightforward — pull the Reach Information link referenced on the product page rather than re-deriving the candidate list locally. Export control is AL:N / ECCN:N, which means no licence flag on a standard cross-border shipment — the part can move on a routine commercial invoice rather than an export-licensed routing.