Does this motor fit a SINAMICS S200 line?
The 1FL2204-4AG00-1HC0 sits in the SIMOTICS S-1FL2 family, built explicitly as the motor half of a SINAMICS S200 drive pairing — so on the controls side it slots into a S200 axis block without a third-party adapter. Power stage runs from a 200 V 3AC supply, with a rated output of 1 kW, a rated speed of 3000 rpm, and both stall torque M0 and rated torque Mn at 3.2 Nm — the flat torque curve across the speed range is what makes a 1FL2 useful on packaging and small pick-and-place axes where you need torque near standstill. Feedback is 17-bit absolute via the hybrid AS connector, shaft height 40 mm, shaft key with tolerance N, and the motor is configured without a holding brake — confirm the axis gravity load before committing, because a no-brake build needs a different safety stop architecture on a vertical axis.
Sealing, feedback, and the integrator checklist
Protection class is IP54 without an oil seal — fine for inside an enclosure or a clean cabinet-side mount, but it is not a washdown-rated servo, so for food-and-bev lines or any zone where jetting or oil splash reaches the shaft the sealing assumption has to be revisited before commissioning. The 17-bit resolution over the hybrid AS connector gives roughly 131,072 pulses per revolution — adequate for the velocity-loop bandwidth a 1 kW SINAMICS S200 axis runs at, and clean enough to keep following error low on a conveyor or small gantry without notch-filter gymnastics. Match the inertia first when sizing the load: 3.2 Nm of rated torque at 3000 rpm is the envelope — for a high-inertia coupling (large pulley, lead screw with a long nut), the torque-to-inertia ratio needs a check against the S200 current-loop headroom before the axis will tune cleanly without singing.
Lifecycle, compliance, and ordering posture
The product class is C: made-to-order, non-returnable, configured per build — order quantities align to the single-piece quantity unit and the 382.00 x 222.00 x 240.00 mm packaging carton, not to shelf-stock replenishment. Ordering flows through the standard quoted-to-order channel: configuration confirmed against the SINAMICS S200 axis list, build slot and quantity-break pricing returned at RFQ.