Drop-in match for an S200 axis on a 200 V cabinet
The 1FL2204-4AG10-1SC0 is a SIMOTICS S-1FL2 low-inertia servomotor sized for a 1 kW axis on a 200 V three-phase bus, with a rated speed of 3000 rpm and a 3.2 Nm continuous / standstill figure on a 40 mm shaft height — the same SH40 frame the 1FL2 line pairs with the SINAMICS S200 drive family. The cable exit is a hybrid connector carrying power plus the 21-bit absolute encoder, and the unit ships with a holding brake and a keyed N-tolerance shaft — so the swap into an existing S200 axis is mechanical and feedback, not a firmware rework.
IP54, holding brake, and what that means on the line
IP54 on the body (without an oil seal) is a panel-side rating — the motor tolerates dust and light splash typical of an enclosure wall or a guarded machine frame, but it is not a washdown food-and-bev rating and it is not the sealed connector-end barrier a wet zone demands. The integrated holding brake is sized for the 3.2 Nm shaft load — fine for vertical-axis static holding and E-stop stopping, not a continuous service brake — and the hybrid connector consolidates power and the 21-bit signal so only one cable routes back to the S200.
Compliance and documentation on file
Export classification is AL:N / ECCN:N — no strategic export licence is required for the usual industrial destinations, but the product is class C, built to order, non-returnable and non-reusable, so a cancelled BOM line is a sunk cost.
Sourcing posture for the BOM line
Because it is built to order, the right channel is quoted-to-order against an RFQ tied to the BOM quantity and the SINAMICS S200 drive pairing — current pricing and production lead are confirmed at quote time, and the order ships as a single-piece unit in the listed 382 x 222 x 240 mm pack.