Where does this 1FL2 sit on a SINAMICS S200 line?
The 1FL2205-2AF01-0MB0 is a SIMOTICS S-1FL2 servomotor in shaft height 48 mm, supplied at 400 V 3AC with a rated power of 1 kW, a rated speed of 3000 rpm, a continuous torque of 3 Nm at rated point, and a stall torque of 3.6 Nm — the motor the SINAMICS S200 drives are sized to command on packaging and small-assembly cells where 1 kW of dynamic torque is the working point. It is built around an absolute encoder with 21-bit resolution, an angular connector exit (AM21), a plain shaft with tolerance N, no holding brake, and an oil-sealed IP65 housing — meaning the shaft seal holds out coolant and light washdown, but the unit is not a food-grade or outdoor-rated enclosure.
How the ratings drive fit
The 1 kW / 3000 rpm pairing at 400 V 3AC is the working envelope — the 3 Nm rated torque multiplied by the rated speed lands at the 1 kW shaft figure — so sizing the gearbox or coupling to the 3 Nm continuous figure (not the 3.6 Nm stall) is the correct baseline; the stall figure is a thermal ceiling, not a duty point. The shaft height of 48 mm and the angular connector with the AM21 plug family orient the cable exit away from the coupling, which keeps the bend radius clean on packaging-machine frames where the motor sits on its side or inverted.
Production status and how it lands on the BOM
The official lifecycle record shows the part as active under productStatus, so it stays on the build schedule for new BOMs; the product class notes that the item is produced to order and cannot be returned against credit, which means stocking decisions and any safety stock for a line-down event need to be set against the made-to-order lead time rather than off-the-shelf expectation.