What this motor is and why someone is sourcing it
The 1FL2310-6AC01-0SB0 is a SIMOTICS S-1FL2 servomotor from the 1FL2 family built for pairing with the SINAMICS S200 drive, listed as Active on the line. Its shaft height 90 mm frame, 400 V 3AC supply, and AS21bit absolute encoder mark it as a mid-frame S200 system motor rather than a general-purpose induction unit. Because the product class is C — made-to-order, non-returnable, non-reusable — this is not a stock-shelf item. Quoting is the correct path: matched against the SINAMICS S200 firmware at order time, not pulled from a returns-friendly inventory pool.
Ratings that decide fit on a SINAMICS S200 axis
Continuous rated power is 7 kW with a rated speed of 2000 rpm and a rated torque of 33.4 Nm; the standstill torque of 35.2 Nm gives a tight overload headroom for acceleration and deceleration ramps without dropping to a larger frame. For sizing, the 33.4 Nm continuous figure governs the steady-state load — momentary excursions up to 35.2 Nm are within the motor's own envelope. The motor is built for 400 V three-phase supplies and carries an AS21bit absolute encoder on a plain shaft, tolerance N, with no holding brake specified. On a vertical axis the absence of a holding brake means the mechanical holding function must be supplied downstream — typically a separate brake on the gearbox or a brake variant from the same family. IP65 with an oil seal keeps the sealing path closed against splash and light coolant exposure typical on machine tools and packaging lines. The oil seal is the wear item on this configuration — re-greasing interval and seal condition belong on the maintenance schedule, not on the commissioning checklist.
Compliance and what ships with the line
RoHS compliance has been in force since 01-01-18, and the line carries the REACH Art. 33 duty-to-inform note referencing the current candidate list. For EU-panel builders these are the two baseline attestations most procurement gates check before releasing a BOM line. Export-control markings read AL:N / ECCN:N, so the motor is not flagged for special export paperwork on the standard shipping route. Internal catalog codes for the line are Group R220 and Product Group X0DM — useful as cross-reference keys when matching against an OEM parts list.
Sourcing posture for a made-to-order servomotor
The line is Active and the product class is built-to-order, which sets the sourcing rhythm: each unit is produced against the order rather than drawn from returns inventory, so lead time is calibrated to production scheduling rather than stock rotation. Independent distribution handles these by quoting to order against the BOM and confirming availability and current pricing at the quote point.