7 kW continuous with the 35 Nm class torque envelope
The 1FL2310-6AC11-1MB0 is a SIMOTICS S-1FL2 synchronous servomotor from the 1FL2 family designed to run with the SINAMICS S200 drive system. Its continuous rating sits at 7 kW shaft power at 2000 rpm, with a standstill torque M0 of 35.2 Nm and rated torque Mn of 33.4 Nm — so the operating torque envelope is narrow, typical of a constant-torque servo sizing where peak torque excursions are absorbed by the drive's current headroom rather than the motor's thermal margin. The mechanical envelope is a 90 mm shaft height with an AM21 21-bit single-turn absolute encoder, an angular connector exit, a keyed shaft with Tolerance N fit, and an integrated holding brake. Protection class is IP65 with an oil seal — sealed against low-pressure water jets and oil splash typical of machine-tool and conveyor service, but not rated for submerged or high-pressure washdown duty. Supply voltage is 400 V three-phase, so it lands on the same industrial three-phase bus that feeds the matched SINAMICS S200 converter — no step-down transformer is needed when the cabinet already runs a 400 V three-phase feed. The matching drive is explicitly the SINAMICS S200; pairing with a different drive family is not in scope here.
Production status and documentation on the BOM line
The product class is C — built-to-order, non-returnable — which is standard for configured servomotors and means order quantities pull from factory production rather than shelf stock. Compliance documentation covers RoHS conformity since 01-01-18 and REACH Article 33 candidate-list information, so the declaration pack for a CE-marked cabinet build is in place.
Procurement posture for a configured servo line
The packaging footprint of 595 x 369 x 407 mm for a single piece is sized for the motor's shipping crate, not a stock bin.