Form-factor and what ships under one order code
The 1FL6062-1AC61-2LH1 is a Siemens SIMOTICS S-1FL6 servomotor from the 1FL6 family built to mate with the SINAMICS V70 and V90 converters. The shaft-height 65 mm frame ships under a single piece-quantity with an angle connector and a plain shaft held to Tolerance N. Operating voltage is 3AC 400 V with a rated power of 1 kW, a rated speed of 2000 rpm, a standstill torque M0 of 6 Nm and a rated torque MN of 4.78 Nm. Feedback is an absolute encoder with 20-bit resolution — 12 bits of multi-turn — so position is retained across a power cycle without a homing routine on restart.
Holding brake, sealing, and converter pairing
An integrated holding brake is specified on this variant, which holds the shaft at standstill after the drive enable is removed — a standard fit for vertical axes and gravity-loaded loads where the servo must not back-drive on a fault. Degree of protection is IP65 with the supplied sealing ring; with the connector seated, the cable entry keeps the motor body sealed against coolant splash and dust typical of machine-tool and packaging-line enclosures. The motor carries the low-voltage 3AC 400 V class rating and is declared compatible with the SINAMICS V70 and V90 drive platforms — pairing outside that converter list is not covered by the listing and should be confirmed at the system level before commissioning.
Compliance documentation on record
RoHS conformity is documented since 01-01-18, and REACH Article 33 duty-to-inform applies per the current candidate list — the declaration trail for this code runs through Siemens' standard conformity pack rather than a project-specific certificate. Order class is C — product manufactured to specification, non-returnable against credit — so a confirmed PO before release is the right expectation.
Lifecycle status and supply posture
With that posture, the realistic supply channels are quoted-to-order against the BOM and independent surplus for urgent line-side needs; lot traceability and date-code confirmation are confirmed at RFQ rather than at the catalog level.
Order-line identifiers
Group Code is R220 and Product Group is 5183 — the internal ordering keys used on Siemens PO lines for this frame size. Packaging quantity is one piece per shipper box with outer dimensions of 466.00 x 264.00 x 290.00 mm.