What 1FT2204-5AK10-0RB0-Z Q01 puts on the shaft
The 1FT2204-5AK10-0RB0-Z Q01 is a Siemens SIMOTICS S-1FT2 CT synchronous servo motor — a compact M0=2.4 Nm / PN=0.57 kW / nN=6000 r/min axis drive built around a resolver and a holding brake, so it closes a position loop on the factory floor and holds the load when the controller drops the enable. The Pt1000 winding temperature sensor rides on the same signal cable as the resolver, so thermal protection is read back from inside the motor without an extra cable run.
Feedback, brake, and the two M17 connectors
Resolver 2p feedback means the drive counts absolute electrical angle through one mechanical turn without a battery-backed encoder, which suits plants that cannot tolerate encoder-battery replacement on the route. The holding brake rides on the motor body so the axis stays put when the bus drops — out here in the grease, that is the difference between a clean E-stop and a load that walks down on a vertical slide. Both the signal lead (resolver + Pt1000) and the power lead terminate in M17 connectors, so the cabinet end is a mating-cordset spec rather than a hard-wired pigtail — confirm the drive-side mating cordset and pinout against the SINAMICS commissioning guide for the controller actually being used, since M17 keying on the 1FT2 family is not universal across the wider 1FK / 1FT ranges.
Compliance and export posture
Group code R220 and product group X033 identify the line within the manufacturer's own ordering data for traceability into the bill of materials.
Where this leaves the BOM
Because the product class is built-to-order with no return-for-credit window, the right move on the procurement side is to specify the configured MPN into the BOM at the same time the controller is specified — the option suffix Q01 has to match the wiring drawing at the bench, and a wrong-suffix motor that has already shipped cannot be sent back against credit.