It is designed for control-circuit switching, not motor loads — think signal isolation, PLC input extension, or interposing relay duty in a panel. Its headline rating is 10 A at AC-12, which covers resistive and solid-state loads common in control circuits. At 24 V it carries 10 A; at 230 V it drops to 6 A; at 400 V it's 3 A. Mechanical endurance is spec'd at 30 million operating cycles, which is typical for a control-circuit device in a high-duty-cycle line.
Mounts via screw or snap-on to DIN rail. The 45 mm width (3 module spaces) fits standard enclosure rail — no oddball footprint. That means it fits in a crowded gland plate or a tight sub-panel without forcing a re-layout. That's the standard range for control wiring — no need for special ferrules or oversized terminals. Front-side IP20 means it's touch-safe once installed, but it's not sealed against washdown; keep it inside the enclosure.