It carries two normally-open instantaneous contacts, rated for 10 A at 24 V and 10 A at 230 V, with a 24 VDC coil that pulls 4 W to close and holds at 4 W. It mounts via screw or snap-on onto a standard 35 mm DIN rail, and the S00 footprint — 45 mm wide, 70 mm tall, 73 mm deep — means it takes up a single 45 mm slot in a panel.
The 24 VDC coil is the control voltage — that's what the PLC output or pushbutton circuit must supply. The 4 W holding power is low enough to be driven by a standard 24 VDC power supply without a separate interposing relay, but the coil's closing power is also 4 W, so there's no inrush spike to worry about. The contact ratings at different voltages tell you what load it can switch at each voltage level: 10 A at 24 V, 10 A at 230 V, 3 A at 400 V, 1 A at 690 V. These are the thermal current ratings for the contacts in AC duty — the actual switching capacity for motor or inductive loads will be lower, but for control-circuit isolation or signaling these are the numbers to match against your load. Storage range extends to -55 to +80 °C, which covers shipping and warehouse conditions.
For a procurement buyer filling a BOM line, this is a straightforward RFQ item: the part is specified, the ratings are clear, and there's no lifecycle risk. The SIRIUS series is widely stocked, so the lead time should be standard for the line — no special factory order required unless volumes are high.
Width is 45 mm.