It mounts via screw or snap-on onto standard 35 mm DIN rail, and the mounting position allows +/-180° rotation on a vertical surface plus +/-22.5° tilt forward and backward, so it fits tight enclosures without reworking the panel layout.
Rated at 10 A at 24 V, this contactor handles typical PLC output loads, pilot lights, and small solenoid valves without an interposing relay. Arcing time runs 10 to 15 ms, so the contact gap clears quickly enough to protect downstream solid-state inputs from prolonged arc energy.
Mounting and Spacing
The 45 mm width and 73 mm depth let it nest alongside S00 contactors on the same DIN rail without crowding. Clearance requirements: 10 mm upwards, 10 mm forwards, 10 mm downwards, 6 mm at the side. That means you can pack three of these across a 140 mm DIN section and still have room for wiring ducts. The screw terminals accept 2x 0.5 to 4 mm² solid or stranded wire, so no special ferrules needed for standard control wiring.