It integrates motor protection via a bimetal overload relay (CLASS 10 trip class) and short-circuit protection through circuit-breakers, all in one IP55-rated enclosure sized at 182 x 220 x 145 mm (W x H x D). Rated at 2.5 A in AC-3 duty at 400 V, this starter handles motor loads up to that current — typical for small conveyors, pumps, or fans on a 50/60 Hz line. Communication is over AS-Interface (the protocol is supported), with a DC control supply of 20.4 to 26.4 V powering the electronics. The operating voltage range is 340 to 440 V AC, so it fits 400 V class three-phase systems common across European and Asian industrial panels.
This flexibility helps when fitting into existing enclosures where the gland plate or busbar layout forces an angled install — common in retrofit or tight panel builds. IP55 means the enclosure is dust-protected and resists water jets from any direction, so it can live in washdown areas or outdoors under a roof. The 182 mm width and 220 mm height fit standard 600 mm wide enclosures with room for side-by-side starters and cable ducts.