It carries a 24 V 50/60 Hz coil, an instantaneous auxiliary contact rated 10 A at 24 V, and delivers 3 kW at 400 V AC-3 or 4 kW at 690 V AC-3. The screw-type terminals accept 2x (0.5 to 4 mm²) conductors, and the contactor mounts via screw or snap-on onto 35 mm DIN rail per EN 50022.
The S00 frame size (45 mm wide, 57.5 mm high, 72 mm deep) is the smallest SIRIUS contactor footprint — it fits tight DIN-rail layouts where panel space is at a premium. The 10 A auxiliary contact at 24 V covers PLC-level signal switching; the 2 A rating at 60 V and 0.3 A at 220 V show it can handle pilot-duty loads across common control voltages. Motor power ratings of 3 kW at 400 V AC-3 and 4 kW at 690 V AC-3 define the maximum three-phase induction motor it can switch under normal starting duty. For AC-4 (plugging/reversing) at 400 V, the current limit drops to 6.5 A — a key derating factor if the application involves frequent inching or reversing. Short-circuit coordination is specified: with type 2 coordination (limited damage to contactor after fault), use a gL/gG fuse rated 20 A; with type 1 coordination (contactor may need replacement), use 35 A. This matters for selectivity studies and fuse sizing in the feeder circuit.
The 3RT1015-1AB01-ZW96 is a general-purpose power contactor for switching three-phase motors up to 4 kW in conveyors, pumps, fans, compressors, and small machine tools. It also switches resistive loads (AC-1) up to 10 A, making it suitable for heater banks and lighting contactor panels. The IP20 finger-safe terminals on the front and at the connection side mean it can be installed in open control panels without additional shrouding.