It uses a 24 VDC coil and spring-type terminals for the magnet coil, with screw and snap-on mounting onto 35 mm DIN rail per DIN EN 60715. The S00 frame keeps it compact — 45 mm wide, 70 mm tall, 73 mm deep — so it fits tightly on the DIN rail without crowding adjacent devices.
The 24 VDC coil holds at nominal voltage and drops out reliably below the pickup threshold — no exceptions. Spring-type terminals accept solid or stranded conductors from 0.5 to 4 mm², and up to 2x (0.5 to 4 mm²) for paralleled feeds, so you can land the power wiring without ring lugs or ferruled ends if the wire is solid. The contactor is rated for AC-3 switching duty at up to 750 operating cycles per hour, and AC-4 (inching/jogging) at 250 cycles per hour — the AC-4 figure is the one that governs if your application does frequent plugging or reversing. Operating temperature range is -25 to +60 °C; storage range extends to -55 to +80 °C, which is the handling limit, not the running limit.
Mounting position allows +/-180° rotation on a vertical surface, and the contactor can be tilted forward and backward by +/-22.5° — useful when the DIN rail sits at an angle in a tight enclosure. Minimum clearances to adjacent devices: 10 mm upwards, 10 mm forwards, 10 mm downwards, 6 mm at the sides. That 6 mm side clearance is tight; if you're stacking contactors side-by-side without a gap, you'll need to check the heat dissipation for continuous duty.