Panel fit and frame size
Coil and terminal wiring
The magnet coil is rated 24 V AC/DC — the same part number covers both supply types, simplifying BOM management. The coil terminals are screw-type, accepting 2x (0.5...1.5 mm²), 2x (0.75...2.5 mm²), or 2x 4 mm² solid or stranded wire. That covers common control-circuit wiring from 20 AWG through 12 AWG without needing ring lugs or ferrules (though ferrules are fine). An auxiliary switch is built in — no separate add-on block needed for basic status feedback. The contactor is rated for 10 A at 24 V, 10 A at 230 V, and 3 A at 400 V for the auxiliary contacts, covering typical PLC input and relay interface signals.
Thermal and switching performance
The contactor is rated for AC-1 duty at up to 1000 operating cycles per hour and DC duty at up to 10 000 operating cycles per hour. That covers unheated plant floors and unconditioned warehouses. The 0.25 power factor at 50/60 Hz indicates the coil's reactive draw — relevant for transformer-coupled control circuits where multiple contactors may share a single 24 V supply.