Skip to main content
Siemens 3RW5247-6TC14

Siemens 3RW5247-6TC14 Soft Starter, 200 A, 200-480 V, SIRIUS

MPN 3RW5247-6TC14
Active

Siemens SIRIUS 3RW5247-6TC14 soft starter, 200 A minimum rated current, 200-480 V operating voltage, PROFIBUS/Modbus RTU/Modbus TCP/EtherNet/IP, Class 10A/10E/20E, screw fixing, 210 x 393 x 203 mm.

Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for machine-down parts
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent China distributor & stockist· Listing updated Sep 2026

Specifications

3RW5247-6TC14 specifications
ParameterValue
Mountingscrew fixing
Depth203 mm
Width210 mm
Height393 mm
Trip classCLASS 10 A (default) / 10E / 20E; acc. to IEC 60947-4-2
Service factor1
Digital output version2 normally-open contacts (NO) / 1 changeover contact (CO)

Product details

Motor current floor and trip class selection

The 3RW5247-6TC14 is rated for a minimum motor current of 200 A — this sets the floor for the soft starter's operating range, not the ceiling. The operating voltage spans 200 to 480 V, covering standard low-voltage motor supplies in North America (208/240/480 V) and Europe (230/400 V). Trip class is configurable as CLASS 10A (default), 10E, or 20E per IEC 60947-4-2. Class 10A is the standard for most pump and fan starts; switch to 20E only when the load inertia demands a longer acceleration ramp and the upstream protection is coordinated for the extended thermal stress.

Fieldbus connectivity for PLC integration

This soft starter ships with onboard PROFIBUS, Modbus RTU, Modbus TCP, and EtherNet/IP — no add-on communication module needed for these four protocols. PROFINET support is also listed, and PROFIenergy is available when used with the PROFINET standard communication module. The Modbus TCP and EtherNet/IP ports allow direct connection to a plant-wide control network without a gateway. For existing PROFIBUS lines, the integrated DP interface eliminates a separate bus coupler in the panel.

Physical envelope and mounting constraints

Dimensions are 210 mm wide, 393 mm high, and 203 mm deep — a substantial footprint that requires a backplate cutout or DIN-rail alternative (screw fixing is the listed fastening method). Clearance requirements: 100 mm above, 75 mm below, 10 mm in front, 5 mm at the sides, and 0 mm behind — plan the enclosure depth accordingly. Mounting position allows a vertical surface with +/-90° rotation and +/-22.5° tilt forward/backward.

Regulatory approvals and compliance documentation

For documentation packages (RoHS, REACH, IEC declarations), these are available from Siemens' standard document portal; the order code carries the full compliance set.

MPN
3RW5247-6TC14