BOM / RFQ

Siemens 6AG1132-6FD00-7CU0 — PLCs (Programmable Logic Controllers)

Siemens 6AG1132-6FD00-7CU0 ET 200SP DQ, Phase Control

MPN6AG1132-6FD00-7CU0

Active

Siemens SIMATIC ET 200SP digital output module 6AG1132-6FD00-7CU0, DQ, phase control 8.5...100%, up to 8 A per channel derated to 4 A at 60 °C, wire-break detection, BU type U0.

Add to RFQ

Siemens 6AG1132-6FD00-7CU0 datasheet (PDF)

Sourced new & surplus through independent channelsAuthenticity-screened · ESD-safe packingListing updated Aug 2026

Specifications

6AG1132-6FD00-7CU0 — I/O
Parameter	Value
Digital outputs	4
Input data area	+ 1 byte for QI information
Output data area	8 byte

6AG1132-6FD00-7CU0 — Electrical
Parameter	Value
Current consumption (rated)	8 mA; without load
Power loss (typ.)	9 W; Active power, load voltage 230 V, all outputs loaded with 2 A, 50 Hz
Short-circuit protection	No; external fusing necessary

6AG1132-6FD00-7CU0 — Environmental
Parameter	Value
Installation altitude, max.	2 000 m
Operating temperature, min. (horizontal mounting)	-40 °C; = Tmin (incl. condensation/frost)
Operating temperature, max. (horizontal mounting)	70 °C; = Tmax
Ambient temperature vs. altitude/pressure derating	Tmin ... Tmax at 1 140 hPa ... 795 hPa (-1 000 m ... +2 000 m)

6AG1132-6FD00-7CU0 — Mechanical
Parameter	Value
Width	20 mm
Height	73 mm
Depth	58 mm
Weight (approx.)	50 g

Product details

Digital output module for ET 200SP with phase control

The 6AG1132-6FD00-7CU0 is a SIMATIC ET 200SP digital output module with phase-angle control for loads such as heaters and lamps. It switches AC loads from 24 V to 230 V AC and provides diagnostic alarms and channel-by-channel wire-break detection. Phase control spans 8.5% to 100% of the phase angle, enabling fine power regulation for resistive loads. In DQ mode, maximum switching rate is 1 Hz; in phase-control mode, output frequency is limited by line frequency. Mounts on BU type U0 base units, supporting 1-wire, 2-wire, or 3-wire connection. Automatic encoding and firmware update are supported.