The 4-20mA input is the standard analog control signal across process plants; this positioner accepts it directly without needing a separate I/P converter. The double-acting design means it drives both sides of a pneumatic actuator cylinder, suitable for spring-return or double-acting actuators where fail-safe action is handled externally. The Ex d (flameproof) enclosure allows installation in Zone 1 / Division 1 hazardous areas where explosive atmospheres may be present during normal operation. The stainless steel housing provides corrosion resistance for offshore, chemical, or hygienic environments where washdown or aggressive atmospheres are routine. Non-contacting position sensing (NCS) eliminates the mechanical linkage and potentiometer wear that plague older positioner designs, reducing calibration drift over the valve's service life. For a plant running 15-year horizons, this means fewer mid-cycle recalibrations and no potentiometer replacement.
Integration Notes
Mounts directly to linear and part-turn actuators via the standard NAMUR interface. The double-acting output requires two pneumatic lines to the actuator; ensure your actuator accepts dual-pilot pressure. The Ex d enclosure means conduit entry must maintain flameproof integrity — use certified cable glands and seal fittings per the installation drawing. Part of the SIPART PS2 family, which shares a common configuration tool and HART communication protocol across variants. If your plant standardizes on PS2, this unit integrates into the existing spares pool and technician training base.