Siemens 6EP1433-2CA00
MPN6EP1433-2CA00
********* spare part ********** SITOP PSU300P 8 A stabilized power supply in degree of protection IP67 input: 400-480 V 3 AC output: 24 V DC/8 A
StockContact for availability
MOQ1 pcs
Sourced new & surplus through independent channelsListing updated Jun 2026
Specifications
| Parameter | Value |
|---|---|
| Fuse protection type | T 4 A |
| Type of signal at output | max. 30 V, 10 mA; Power-Good (High-Pegel 1L+ for Vout in range 21.3 ... 29 V); Overtemperature warning at least 30 s before switch-off (high level 1L+ when the max. internal temperature is exceeded) |
| Type of electrical connection | screw-type terminals |
| Type of the power supply network | 3-phase AC |
| Voltage curve at output | Controlled, isolated DC voltage |
| At rated input voltage 400 | 0.5 A |
| Output voltage at DC rated value | 24 V |
| On slow fluctuation of input voltage | 0.5 % |
| Relative overall tolerance of the voltage | 3 % |
| Product function output voltage adjustable | No |
| Behavior of the output voltage when switching on | Overshoot of Vout < 2 % |
| At rated output voltage for rated value of the output current typical | 25 W |
All specifications+67 ▾
| Parameter | Value |
|---|---|
| Relative control precision of the output voltage with rapid fluctuation of the input voltage by +/- 15% typical | 0.5 % |
| At Short-Circuit during operation | 100 ms |
| Design of Short-Circuit protection | Electronic shutdown, automatic restart |
| On Short-Circuiting during the Start-Up | 100 ms |
| At Short-Circuit during operation typical | 50 A |
| Property of the output Short-Circuit proof | Yes |
| On Short-Circuiting during the Start-Up typical | 50 A |
| Current limitation of inrush current at 25 °C maximum | 40 A |
| Buffering time for rated value of the output current in the event of power failure minimum | 15 ms |
| Supplied active power typical | 192 W |
| Line frequency | 45 ... 66 Hz |
| Depth of the enclosure | 90 mm |
| Width of the enclosure | 310 mm |
| Height of the enclosure | 135 mm |
| Product feature of the enclosure housing can be lined up | No |
| CE marking | Yes |
| UL approval | Yes; UL-Listed (UL 508) according to NFPA compatibility (National Fire Protection Association), see operating instructions |
| CSA approval | No; - |
| EAC approval | Yes |
| ULhazloc approval | No |
| Environmental category according to IEC 60721 | Climate class 3K3, 5 … 95% no condensation |
| ATEX | No |
| IECEx | No |
| DNV GL | No |
| Typical | 0.4 mA |
| At input | L1, L2, L3, PE: Plug connector HAN Q4/2 (counterpart see "Electrical accessories") |
| At output | L+, M: 1 x 2 mm² each (2-pole cable for +/- with open, labeled ends, 2 x 2 mm²) |
| NEC class 2 | No |
| Rated range | 0 ... 8 A |
| Rated value | 8 A |
| 1 rated value | 50 Hz |
| 2 rated value | 60 Hz |
| In the feeder | Required: Circuit breaker 3RV2011-1DA10 or 3RV2711-1DD10 (UL 489) |
| Initial value | 340 V; 320 ... 340 V for max. 1 min |
| During storage | -40 ... +70 °C |
| FM registration | No |
| During operation | -25 ... +55 °C; with natural convection |
| During transport | -40 ... +70 °C |
| Mounting | Can be mounted onto ET200pro mounting rail |
| Full-Scale value | 550 V |
| I2t value maximum | 3.5 A²·s |
| Other information | Specifications at rated input voltage and ambient temperature +25 °C (unless otherwise specified) |
| Galvanic isolation | Safety extra-low output voltage Uout acc. to EN 60950-1 and EN 50178 |
| Maximum rated value | 480 V |
| Minimum rated value | 400 V |
| Protection class IP | IP67, enclosure type 5 indoor |
| Bridging of equipment | No |
| Efficiency in percent | 88 % |
| Electrical accessories | Power connector (3RK1911-2BE50 (2.5mm²)) |
| For auxiliary contacts | Alarm signals: M12 plug-in connector 5-pin |
| Response delay maximum | 1.5 s |
| For emitted interference | EN 55022 Class A |
| Nippon kaiji kyokai | No |
| For interference immunity | EN 61000-6-2 |
| cCSAus, class 1, division 2 | No |
| At output 1 at DC rated value | 24 V |
| Overvoltage overload capability | Implemented internally with varistors |
| Design of input wide range input | Yes |
| Lloyds register of shipping | No |
| On slow fluctuation of ohm loading | 0.5 % |
| Operating resource protection class | Class I |
| Design of the overvoltage protection | < 33 V |
| Display version for normal operation | Green LED for 24 V OK |
| French marine classification society | No |
| Operating condition of the mains buffering | at Vin = 400 V |
| Galvanic isolation between input and output | Yes |
| American bureau of shipping europe ltd. | No |
MPN
6EP1433-2CA00