Siemens SIMATIC ET 200SP digital input module, 230 V AC, DI Yes, MSI No, 1 byte input data, 20 × 73 × 58 mm, requires BU type B1 base unit.
| Parameter | Value |
|---|---|
| Number of digital inputs | 4 |
| Max. inputs, up to 60 °C | 10 A |
| 2-wire sensor support | Yes |
| Parameter | Value |
|---|---|
| Input voltage at signal "1" | 74 V AC to 264 V AC |
| Input voltage at signal "0" | 0V AC to 40V AC |
| Input current at signal "1" (typ.) | 10.8 mA |
| Power loss (typ.) | 1 W; Active power, load voltage 230 V, all inputs connected with 230 V, 50 Hz |
| Cable length, unshielded, max. | 600 m |
| Cable length, shielded, max. | 1 000 m |
| Parameter | Value |
|---|---|
| Input delay 0 to 1, min. | 1.5 ms |
| Input delay 1 to 0, min. | 10 ms |
| Input delay 0 to 1, max. | 4 ms |
| Input delay 1 to 0, max. | 10 ms |
| Input delay, parameterizable values | No |
| Parameter | Value |
|---|---|
| Short-circuit protection | No |
| Short-circuit (NAMUR sensor) | No |
| Diagnostic alarm | No |
| Hardware interrupt support | No |
| Isolation between channels | No |
| Isolation between channels and backplane bus | Yes |
| Isolation test voltage | 2 545 V DC/2 s (routine test) |
| Parameter | Value |
|---|---|
| Depth | 58 mm |
| Height | 73 mm |
| Width | 20 mm |
| Parameter | Value |
|---|---|
| Rated value (AC) | 230 V |
| Address space per module, max. | 1 byte; + 1 byte for QI information |
The 6ES7131-6FD00-0BB1: Input data is presented as a single byte on the backplane. The module supports I&M data (levels 0 to 3) and a group error diagnostic alarm, but no per-channel diagnostics for wire-break or short-circuit. Firmware V1.0 ships standard, and field updates are possible.
Maximum cable length: 1 000 m shielded, 600 m unshielded. Keep that in mind for field wiring runs.
No related articles