Siemens SIMATIC ET 200SP, Digital Output Module (DQ), 8× DC 24 V / 2 A, with diagnostics and wire-break detection, order code 6ES7132-6BD20-2BA0.
| Parameter | Value |
|---|---|
| Digital outputs | 4 |
| Output type | Source output (PNP, current-sourcing) |
| Parameter | Value |
|---|---|
| Rated value (DC) | 24 V |
| Output current, resistive load, max. | 100 Hz |
| Output current at signal "1" (rated) | 2 A |
| Total output current per module, max. | 8 A |
| Permissible range, upper limit (DC) | 28.8 V |
| Permissible range, lower limit (DC) | 19.2 V |
| Residual current at signal "0", max. | 0.1 mA |
| Output current up to 60 °C, max. | 4 A |
| Power dissipation (typ.) | 1 W |
| Inductive shutdown voltage clamp | Typ. L+ (-50 V) |
| Load resistance, upper limit | 3 400 Ω |
| Load resistance, lower limit | 12 Ω |
| Isolation between channels | No |
| Isolation between channels and backplane bus | Yes |
| Isolation test voltage | 707 V DC (type test) |
| Parameter | Value |
|---|---|
| Short-circuit protection | Yes |
| Reverse polarity protection | Yes |
| Diagnostics function | Yes |
| Diagnostic alarm | Yes |
| Short-circuit response threshold (typ.) | 2.8 to 5.2 A |
| Short-circuit detection | Yes; Module-wise |
| Wire-break detection | Yes; Module-wise |
| Redundant load control | Yes |
| Output can drive a digital input | Yes |
| Parameter | Value |
|---|---|
| Output switching delay 0 to 1, max. | 50 µs |
| Output switching delay 1 to 0, max. | 100 µs |
| Switching frequency, inductive load, max. | 2 Hz |
| Switching frequency, lamp load, max. | 10 Hz |
| Parameter | Value |
|---|---|
| Operating temperature, horizontal mount, max. | 60 °C |
| Operating temperature, horizontal mount, min. | -30 °C; < 0 °C as of FS08 |
| Parameter | Value |
|---|---|
| Cable length, unshielded, max. | 600 m |
| Cable length, shielded, max. | 1 000 m |
| Width | 15 mm |
| Height | 73 mm |
| Depth | 58 mm |
| Weight (approx.) | 30 g |
The 6ES7132-6BD20-2BA0: Mounts on a BU type A0 base unit. Supports 1-, 2-, and 3-wire connections directly on the base unit; 4-wire requires a potential distributor module. Automatic encoding via the base unit simplifies configuration. Firmware version V1.1, supports I&M data 0 to 3.
Current, stocked through multiple Siemens distribution lanes. Quoted to order; send an RFQ for lead time and quantity.
No. The 6ES7522-1BH01-0AB0 is an S7-1500 backplane module; this ET 200SP module requires a BU type A0 base unit and fits only ET 200SP stations. Rewiring the I/O bus is necessary.
Alternative models and sibling configurations in the same Siemens series. For obsolete or discontinued parts, these models can serve as compatible replacements or functional alternatives for plant maintenance.
No related articles